Direct Drive 40:75 2in. Drive Shaft Kit

Direct Drive 40:75 Drive Shaft Kit

The A-Drive 40:75 1.5-inch Drive Shaft Kit is designed to mount into the drive pipe section of the 40:75 double worm reducer gearbox. The driveshaft end with the input tab slides into the double worm reducer gearbox. Using the mounting holes on the opposite side of the drive shaft, attach the drive pipe with the bolt and nut provided. Made from hardened steel then zinc-plated for protection against marine conditions. The driveshaft will accept a KALS Limit Switch.

Kit Includes:
(1) A-Drive 40:75 Double Worm Reducer Gearbox Drive Shaft w/  Input Tab
(1) 1/2″ x 3 1/2″ Zinc-Plated Grade 5 Hex Head Bolt
(1) 1/2″ Zinc-Plated Nylock Nut

• Attaches direct drive boat hoist to a drive pipe
• Made from hardened steel then zinc-plated
• Withstands marine environments
• Fits BH-USA A-Drive Direct Drive Hoist systems
• Machined tab input
• Drive Pipe ID: 2 in.
• Dimensions: 12 3/4 in. x 1 7/8 in. x 1 7/8 in.
• Input: 1 7/8 in. x 1 1/4 in. x 5/8 in.
• Output: 8 7/8 in. x 1 3/8 in. x 1 3/8 in.
• Mounting Hole Amount: 2
• Mounting Hole Size: 1/2 in.
• Keystock Groove: 4 in. x 1/4 in.
• Keystock Size: 3 1/2 in. x 1/4 in. x 1/4 in.

Please note that BH-USA supplies with all A-Drive drive shafts a GR5 hardened bolt to attach the drive pipe to the shaft. Only use the bolt provided by BH-USA, if you lose this bolt you must call to order another one- Item 82011FA. Do not use any other bolt, by doing so the bolt may shear, dropping your boat.